Assorted Marine Hardware

On board, every detail matters. A hinge that seizes or a screw that loses its seat are not just annoyances - they are signs that the component is not suited for the marine environment. Salt corrosion attacks metals constantly, which is why it is essential to choose specific materials such as AISI 316 stainless steel, which resists oxidation better than standard AISI 304 thanks to its molybdenum content.

When carrying out a repair or a fit-out, always consider the load the part will bear. There is no one-size-fits-all solution for every application. At Nautiba we understand the challenges of boat work and know how frustrating it is to wait for a component that turns out to be incompatible. Our supply process focuses on precision, because we want you to receive exactly what you need, within the time required for correct maintenance.

Before replacing a component, verify the exact measurements and the type of fastener. An oversized screw can damage the gelcoat, while one that is too short will not hold under load. If you are unsure, ask. Our pre-sales technical support analyzes compatibility alongside you, helping you avoid common mistakes that would complicate your work on board.

How to choose the right hardware

Selecting screws and small fittings must be guided by strict criteria tied to the intended use. Not all stainless steel behaves the same way when exposed to salt and high humidity.

• Verify the material: prefer AISI 316 for exterior components or those directly exposed, where corrosion protection is essential.
• Evaluate working load: ensure the chosen component has a breaking load appropriate for its function, especially at structural points.
• Check dimensions: carefully measure diameters, lengths, and thread pitches before purchasing, as tolerances in a nautical environment are tight.
• Consider the backing: for complex mounting situations, verify compatibility with gaskets or backing plates to prevent water ingress.

Can AISI 304 hardware be used on board?

AISI 304 is only suitable for protected, dry interior spaces. On the exterior, especially where humidity and salt spray are present, AISI 316 remains the standard choice to prevent pitting corrosion.

How do I know if a component is under excessive stress?

Signs such as plastic deformation, cracks near mounting holes, or stress marks in the gelcoat around the base are indicators that the component must be replaced or that the load exceeds the part's rated capacity.

How can I verify technical compatibility before purchasing?

You can contact our technical support team. We will analyze the specs of the requested component, comparing them with your installation requirements to confirm whether the part is suitable for the specific application on your boat.